Delta D25886 User Manual Page 226

  • Download
  • Add to my manuals
  • Print
  • Page
    / 339
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 225
4. Motion Control Instructions
DVP-MC operating manual 4-185
If there are multiple rows of codes and E and F in G2 code are omitted, the velocity, acceleration,
deceleration of the cutter are based on E and F in the previous rows of codes before the row where
G2 is. If the previous rows of G codes have not specified E and F, maximum velocity,
maximum acceleration, maximum deceleration in the parameters of X axis will be taken
as reference.
In absolute mode for G90, the terminal point of circular arc is the absolute coordinate value
regarding 0 unit in their own directions as reference. In relative mode for G91, the terminal point of
circular arc is the incremental value of the start point of circular arc.
No matter whether in the absolute mode or in relative mode, the coordinates of the center of a
circle I_J_(I_K_/J_K_) are always the relative coordinates with the start point as reference
T is the quantity of one full circle; the path is the length of arc when T=0; the path is the
corresponding full circles plus the arc length when T is a constant.
The difference between Format 2 and format 1 is that format 2 determines a segment of circular arc
via the start point, terminal point and radius. If the input value to the right of R parameter is positive
number (R+), the circular arc is the minor arc less than 180 degrees; if the input value to the right of
R parameter is negative number (R-), the circular arc is the major arc more than 180 degrees.
The following full lines are the motion path when G3 selects R+ and R- and the arrows on the arc
refer to the motion direction.
The coordinate relations on different planes:
a) XY plane circular arc b) XZ plane circular arc C) YZ plane circular arc
XXY
I
lJ
JK K
RR R
OO O
Y
Z
Z
Start point
Start point Start point
Terminal point Terminal point Terminal point
Center of
a circle
Center of
a circle
Center of
a circle
Please note the relations between the coordinate planes and I, J, K. Only two of I, J and K exist in
one circular arc instruction. Which two exist depends on the corresponding plane, e.g. on XY plane,
only I and J show.
The coordinate plane can be set by G17, G18 and G19. The circular and helical motion paths for
G3 on different coordinate planes are shown as below.
Page view 225
1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 338 339

Comments to this Manuals

No comments