Delta D25886 User Manual Page 240

  • Download
  • Add to my manuals
  • Print
  • Page
    / 339
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 239
4. Motion Control Instructions
DVP-MC operating manual 4-199
3. Stop
If the coordinate motion instruction is being executed, set “Stop” to ON and the execution of the
corresponding coordinate motion instruction will be stopped at the deceleration in coordinate motion
instruction and the state of each axis is Standstill.
If the coordinate motion instruction is executed again, reset “Stop” and then execute DNC_Group
instruction again. Please note that the current position of axis must be consistent with the terminal
position of the coordinate motion instruction to be executed when coordinate motion instruction is
executed again. If the instruction to be executed is the circular instruction, consider if the current point,
the terminal point of arc, center of a circle or radius can make up a circular arc in case of any
abnormality.
4. ManualMode
After “Manualmode” is started up, the running speed of the corresponding coordinate motion
instruction comes from the parameter setting of manual velocity. When “ManualMode” is off, the
execution of the G code which has not completed being executed can continue at the speed and
acceleration set in the original instruction. The source of manual speed can be a constant or some
register.
Page view 239
1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 338 339

Comments to this Manuals

No comments