Delta D25886 User Manual download pdf (Page 265)

Appendix A

A-2 DVP-MC operating manual

2. When COM2 is possessed by PLC, its format is set by D1120 and the meaning of each bit of D1120 can

be seen in table 1. its communication node adress is set by D1121. If the value of D1121 is 1, it indicates

that the communication node address of PLC module is 1. The default communication format for COM2:

Baud rate=9600bps, Data bits=7, Parity=E, Stop bits=1, Mode=ASCII, Address=1

Note:

9 When COM2 serves as Slave communication port, no communication instrument is allowed to exist

in the program.

9 After COM2 communication format is modified, if RUN/STOP switch of DVP10MC11T turns

RUN→STOP, the communication format keeps unchanged.

9 After COM2 communication format is modified, DVP10MC11T power is switched on from off, COM2

will be restored to the communication format of factory setting

3. When COM2 is possessed by motion control module, its format is set by D6516 of motion control module

and the meaning of each bit of D6516 can be seen in table 2. If the value of D6516 is revised, the

communication format will be changed immediately. The default communication format for COM2: Baud

rate=9600bps, Data bits=7, Parity=E, Stop bits=1, Mode=ASCII, Address=2.

Note:

9 After COM2 communication format is modified, RUN/STOP switch of DVP10MC11T turns

RUN→STOP, the communication format keeps unchanged.

9 After COM2 communication format is modified, DVP10MC11T power is switched on from off, the

communication format keeps unchanged.

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 338 339

No comments

Delta D25886 User Manual Page 265