Delta 50-760 User Manual download pdf (Page 11)

11 - English

ATTACHING THE TOP FILTER BAG

1. Place a large 5/16” flatwasher on a 5/16" hex head

screw.

2. Position the bracket (A) on the dust collector (Fig.

12).

3. Insert 5/16" hex head screw through the hole in

the bracket, then thread it into the hole in the dust

collector. Tighten securely with a 12mm wrench.

4. Thread the other two screws into the appropriate

holes and tighten securely.

5. Insert the rod into the pocket on the filter bag (A) Fig.

13.

6. Insert the rod in the hole in the bracket (B).

7. Work the open end of the filter bag into the top

groove of the dust collector drum until it is secure

and sealed. Bend and fold, as necessary, the internal

bag retainer ring to fit it into place.

8. Attach the other filter bag in the same manner.

Model 50-760 provides two 4” dust ports. To attach the

hose:

NOTE: Place the open end (D) of the intake cap rings

around and on the ends of each dust intake port before

attaching the hose.

Loosely attach the hose clamp (A) Fig. 14 around one

end of the flexible hose (B). Attach the hose to the dust

intake port (C). Tighten the hose clamp (A). Attach the

remaining clamp to the other end of the flexible hose and

to the woodworking machine.

NOTE: Do not operate the dust collector with any dust

intake port (C) Fig. 13 uncovered. Place the flat intake

cap (E) on the dust intake port (Fig. 14).

ATTACHING THE HOSE TO THE INTAKE PORT

Disconnect the machine from the power source!

Fig. 12

Fig. 13

Fig. 14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Delta 50-760 User Manual Page 11