Delta 50-761 User Manual download pdf (Page 12)

Fig. 13

Fig. 11

Fig. 12

ATTACHING ACCESSORY HOSE

TO INTAKE PORT

DISCONNECT MACHINE FROM POWER

SOURCE BEFORE CONNECTING OR

DISCONNECTING HOSE .

Model 50-761 provides three 4” dust ports. Proceed as

follows for each port with your accessory hoses.

NOTE: Place open end (D) of intake cap rings around

and onto ends of each dust intake port before attaching

the hose.

To assemble the 4” dust collection hose (not supplied) to

the motor and blower assembly, loosely attach hose

clamp (A) Fig. 13, around one end of flexible hose (B)

and assemble the hose to dust intake port (C). Tighten

hose clamp (A). Assemble the remaining clamp to the

other end of the flexible hose and to the woodworking

machine.

NOTE: See “ACCESSORIES” section of this manual.

NOTE: Do not operate the dust collector with any of the

holes in dust intake port (C) Fig. 13 uncovered. To cover

a hole not being used by a hose, place the flat intake cap

(E) on dust intake port as shown in Fig. 13.

ATTACHING TOP FILTER BAG

1. Assemble 5/16” flatwasher (23 mm diam.) onto

5/16” hex head screw.

2. Position bracket (A) to dust collector as shown in

Fig. 11.

3. Insert 5/16” hex head screw through hole in bracket

and thread into the hole in dust collector. Tighten

securely with a 12 mm wrench.

4. Insert rod (A) Fig. 12 into pocket on filter bag.

5. Insert rod (A) into hole in bracket (B).

6. Work open end of filter bag into top groove of dust

collector drum until secure and sealed. It will be

necessary to bend and fold the internal bag retainer

ring to fit it into place.

7. Attach the other filter bag in the same manner.

DISCONNECT MACHINE FROM POWER

SOURCE

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-761 User Manual Page 12