Delta 50-870 Instruction Manual download pdf (Page 2)

GENERAL SAFETY RULES

Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery,

there are certain hazards involved with the operation of the product. Using the machine with respect and caution

will considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or

ignored, personal injury to the operator may result. Safety equipment such as guards, push sticks, hold-downs,

featherboards, goggles, dust masks and hearing protection can reduce your potential for injury. But even the best

guard won’t make up for poor judgment, carelessness or inattention. Always use common sense

and exercise

caution

in the workshop. If a procedure feels dangerous, don’t try it. Figure out an alternative procedure that feels

safer. REMEMBER: Your personal safety is your responsibility.

This machine was designed for certain applications only. Delta Machinery strongly recommends that this machine

not be modified and/or used for any application other than that for which it was designed. If you have any ques-

tions relative to a particular application, DO NOT use the machine until you have first contacted Delta to deter-

mine if it can or should be performed on the product.

Technical Service Manager

Delta Machinery

4825 Highway 45 North

Jackson, TN 38305

(IN CANADA: 505 SOUTHGATE DRIVE, GUELPH, ONTARIO N1H 6M7)

WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.

1. FOR YOUR OWN SAFETY, READ AND UNDERSTAND THE INSTRUCTION MANUAL BEFORE OPERAT-

ING THE UNIT. Learn the unit’s application and limitations as well as the specific hazards peculiar to it.

2. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

3. DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use this unit in damp or wet locations, or expose it to

rain. Keep work area well-lighted.

4. KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept a safe distance from work

area.

5. DISCONNECT UNIT before servicing.

6. CHECK DAMAGED PARTS. Before further use of the unit, properly repair or replace any part that is

damaged.

1 2 3 4 5 6 7 ... 10 11

No comments

Delta 50-870 Instruction Manual Page 2