Delta AP-100 User Manual download pdf (Page 9)

When suspending the air cleaner from the ceiling or other overhead support, use steel s-hooks that are a

minimum of 1/4".

Thread all lag hooks at least 1-1/2" into supporting structural members.

Keep a minimum of seven feet between bottom of air cleaner and the floor surface

Do not use rope, cable, or power cord to suspend the unit from the ceiling. Use chain rated for a minimum

of a 150 lb. working load.

IMPORTANT: The air cleaner will operate more efficiently when the air flow is unrestricted. Do not locate the unit in a corner or

near heating or cooling vents.

The Air Cleaner is equipped with an in-line rocker switch

(A) Fig. 5 on the power cord (B). To supply power to the

machine, press down on the end of the rocker switch that

has the white dot. To stop power to the unit, press down

on the opposite end.

CORD SWITCH

MOTOR AND LIGHT PULL CORDS

NOTE: The motor and light have independent pull switches,

but the cord switch must be in the “ON” position for them

to operate.

To start and stop the air cleaner motor, pull down on the

motor pull cord (C) Fig. 6. The motor pull cord (C) has a fan

icon to indicate the motor pull cord.

To turn the light "ON" and "OFF", pull down on the light

pull cord (D) Fig. 6. The light pull cord (D) has a bulb icon to

indicate the light pull cord.

FAN ICON

LIGHT ICON

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 5

Fig. 6

Make sure that the switch (C) Fig. 5 is in

the “OFF” position before plugging in the power cord.

In the event of a power failure, move the switch to

the “OFF” position. An accidental start-up can cause

injury.

MACHINE USE

NOTE: The air cleaner may produce a slight odor for the first few hours of operation because of the protective coating applied

to internal components. This odor will dissipate and should be disregarded.

Never operate the air cleaner without air filters in place.

The air cleaner can be used in the overhead position, on a work bench, or on the floor.

The Delta AP100 Air Cleaner can be used for:

a. sanding applications.

b. sawing applications.

c. dry wall applications.

d. any application where non-metallic dust is a factor.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments

Delta AP-100 User Manual Page 9

Comments to this Manuals

Related products and manuals for Air purifiers Delta AP-100