INSTRUCTION MANUALAir Cleaner(Model AP200)PART NO. 906565 - 07-18-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 13To learn more about DELTA MACHIN
10Fig. 165. Fig. 16, illustrates the air cleaner being used in afloor sanding application.Fig. 176. Fig. 17, illustrates the air cleaner suspended fro
113. Remove inner bag filter (J) Fig. 19, in the samemanner.Fig. 19J4. The first stage filter (H) Fig. 18, can be replaced orcleaned depending on its
Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin
2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha
3ADDITIONAL SAFETY RULESFOR AIR CLEANERS1. DANGER: DO NOT USE THIS UNIT TO FILTER METAL DUST. Combining wood and metal dust can createan explosion or
4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a
6AIR CLEANER PARTSFig. 21 - Air cleaner2 - Four 5/16-18x1½" eye-bolts3 - Four 5/16-18 flange nuts4 - Four rubber feet1234
7ASSEMBLY INSTRUCTIONSWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU RE
8MOUNTING THE AIR CLEANER TO THE CEILING OROVERHEAD SUPPORTWARNING: THIS TOOL WEIGHS APPROXIMATELY50 POUNDS. MAKE CERTAIN THE UNIT IS SECURELYSUPPORTE
OPERATING CONTROLSON/OFF SWITCHThe Air Cleaner is equipped with an in-line rocker switch(M) Fig.11, located on the power cord (N). To start orstop the
Comments to this Manuals