Delta BLD-E1 brushless DC motor drive BLD-E1 Series User Manual Page 123

  • Download
  • Add to my manuals
  • Print
  • Page
    / 186
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 122
Chapter 4 ParametersAT |Troubleshooting}| BLD-E1 Series
4-82
Revision May 2009, 00DE, V0.50
09-04
Communication Protocol
Control
mode
VF VFPG FOCPM
Factory Setting: 1
Settings 0 Modbus ASCII mode, protocol <7,N,1>
1 Modbus ASCII mode, protocol <7,N,2>
2 Modbus ASCII mode, protocol <7,E,1>
3 Modbus ASCII mode, protocol <7,O,1>
4 Modbus ASCII mode, protocol <7,E,2>
5 Modbus ASCII mode, protocol <7,O,2>
6 Modbus ASCII mode, protocol <8,N,1>
7 Modbus ASCII mode, protocol <8,N,2>
8 Modbus ASCII mode, protocol <8,E,1>
9 Modbus ASCII mode, protocol <8,O,1>
10 Modbus ASCII mode, protocol <8,E,2>
11 Modbus ASCII mode, protocol <8,O,2>
12 Modbus RTU mode, protocol <8,N,1>
13 Modbus RTU mode, protocol <8,N,2>
14 Modbus RTU mode, protocol <8,E,1>
15 Modbus RTU mode, protocol <8,O,1>
16 Modbus RTU mode, protocol <8,E,2>
17 Modbus RTU mode, protocol <8,O,2>
Computer Control /Computer Link
Before using RS-485 Serial Interface, each drive needs to pre-assign a communication
address specified by Pr.9-00. The computer then controls each brushless DC drive according
to its communication address
A BLD-E1 can be set up to communicate in MODBUS networking using ASCII
mode(American Standard Code for Information Interchange), each 8-bit data is a combination
of 2 ASCII character. For example, a 1-byte data: 64Hex, shown as ‘64’ in ASCII, consists of
‘6’ (36Hex) and ‘4’ (34Hex).
1. Code Description:
ASCII mode:
Each 8-bit data is the combination of two ASCII character. For example, a 1-byte data:
64 Hex, shown as ‘64’ in ASCII, consists of ‘6’ (36Hex) and ‘4’ (34Hex).
Character ‘0’ ‘1’ ‘2’ ‘3’ ‘4’ ‘5’ ‘6’ ‘7’
ASCII code 30H 31H 32H 33H 34H 35H 36H 37H
Character ‘8’ ‘9’ ‘A ‘B’ ‘C’ ‘D ‘E’ ‘F
ASCII code 38H 39H 41H 42H 43H 44H 45H 46H
Page view 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 185 186

Comments to this Manuals

No comments