Delta 36-5000 Instruction Manual download pdf (Page 12)

100

ASSEMBLY

(continued)

INCH

FIXED WHEELS AND STATIONARY FEET

1. Attach the two fixed wheels (A) to the two

left leg, opposite the pivot caster, using the

carriage shoulder bolt as in Figure 2.

2. Screw the adjustable feet (C) into the threaded

inserts in the right leg, next to the pivot caster.

3. Lay a scrap piece of 2x4 in back of the saw, as

shown in Figure 3, to prevent damage to the

dust chute when righting the saw.

4. Stand the saw right side up.

The machine is heavy, two

people are required to stand the

machine up.

5. The two adjustable feet (C) can be raised and

lowered by rotating them. The feet may be

adjusted to level the saw and locked in place

with the locking set screws already assembled

in the frame, using a 6mm allen hex wrench.

See Figure 2.

FIGURE 2

FIGURE 3

FIGURE 4

EXTENSION WINGS

For Models with Three Extension Wings

1. Attach the left side extension wing (A) to the

table using three 5/16-18 x 7/8” hex head

screws.

2. Lay the two remaining wings upside down on

the saw table. Place the side of the wing that

will mount to the saw table near the edge of

the saw table, so that the hole pattern in the

wing matches the hole pattern of the saw. If

you have cast iron wing, it will mount to the

saw table. Place the other wing adjacent to

the wing so the holes patterns match. Fasten

the two wings together using three 5/16-18

x 7/8 inch hex head screws and mating hex

flange nuts.

3. Turn the two wings fastened together (B) over

and fasten them to the saw table using three

5/16-18 x 7/8 inch hex head screws.

4. Make sure the top edges of the wings are flush

with the top of the table and tighten all six

screws.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 99 100

Comments to this Manuals

No comments

Delta 36-5000 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-5000