Delta 36-5000 Instruction Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
ASSEMBLY
(continued)
FIGURE 7
FIGURE 8
FIGURE 9
FENCE GUIDE AND POWER CONTROL BOX
1. Connect the fence guide tube (A) by inserting the smaller
end into the larger end. See Figure 10
2. Attach the fence guide to the front rail using four (for
30" versions) six (for 52" versions) 1/4-20 x 1/2-inch hex
button head screws and ¼-inch spring washers
through the holes (B) on the bottom side of
the front rail.
3. Align the two holes in the power
control box bracket with the holes
underneath the front rail (C), located
on the left side of the saw. Secure
the power control box to the front rail
using two1/4-20 x 1/2-inch button
head screws.
4. Fix the hanging power cord at rear side of
front rail by wire clip and M5 x 6mm round
head cross screw.
A
B
C
FIGURE 10
WOOD EXTENSION TABLE
52” rip capacity models only
1. Lay the wood table (A) upside down on floor or
bench.
2. Position legs (B) in corner as shown (fig 7) the
vertical wall of the angle plate on the leg should
be against the end wood wall (C) of the table.
3. Fasten the legs to the table board with (8) #8 x
5/8” self-tapping screws (D).
4. Carefully drill through the holes in the vertical
angle plate holes and the wood wall of the table
with a ¼ inch drill. Feed the #10 by 1 ¾” screws
(E) through the drilled holes from the outside,
then assemble the #10 washers and nuts onto
the screws and tighten.
5. Loosely assemble (3) 5/16-18 x 7/8 inch screws,
washers and nuts (F) into the three holes in the
side of the extension wing as shown. (fig 8)
6. Carefully lower the slotted steel angle table
bracket (G) down onto the screws on the
extension wing. Tighten the screws after the
wood table is leveled with the extension wing.
7. Using the rail alignment gauge (H) adjust the
feet in the legs (I) so the top of the table is at the
proper distance from the rail.
8. Drill ¼ inch holes through the rail holes (J) into
the wood table on the front and back rails. (fig 9)
9. Fasten wood table to rails with ¼-20 X 1 ½ inch
screws, flat washers, lock washers, and nuts.
A
B
E
D
C
F
G
I
H
J
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Comments to this Manuals

No comments