Delta 36-5000 Instruction Manual download pdf (Page 21)

100

PREPARING TO CUT

(continued)

FIGURE 19

USING THE MITER GAUGE

The miter gauge is equipped with adjustable index

stops at 90°, 75°, 60°, 45° and 30°. To set the miter for

an angled cut, see Figure 21 and:

1. Loosen the handle (A).

2. Depress the thumb lever (B).

3. Move the body of the miter gauge to the desired

angle.

4. Release the thumb lever and retighten the handle.

The miter gauge is equipped with a washer on the end

of the bar which fits into the t-slot in the table. This

allows the miter gauge to be pulled off the front edge

of the table without falling. This allows for an increased

workpiece capacity in front of the blade.

USING BLADE GUARD

ASSEMBLY

The anti-kickback pawls and blade

guard must be used for all through-

cuts. Keep both guard shields down and arms, hands

and fingers away from the blade, blade guard and

anti-kickback pawls when power is on to prevent

serious injury. See assembly instructions on page 13

for proper installation and removal of anti-kickback

pawls and blade guard.

If there is a need to briefly raise the blade guard (for

example, to make a measurement) the guard can be

parked in a raised position.

1. Refer to Figure 22 and, lifting the guard from the

front, raise the guard shield until it snaps into a

locked position above the table. One or both guard

shields can be raised.

2. When done making the measurement, return guard

to operating position.

CHECKING FENCE ALIGNMENT

Do not attempt to use a rip fence that

is not properly aligned.

Every time you use the rip fence, check its alignment

to make sure the fence is parallel to the miter slot. To

check the alignment of your rip fence, place the fence

adjacent to miter slot and lock the fence in place. If the

fence is not aligned to the miter slot from the front to

the back, see instructions for aligning rip fence on page

29 of this manual. If you are not able to successfully

align the rip fence, replace the rip fence or contact

1-800-223-7278 for further instructions.

FIGURE 21

FIGURE 22

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 99 100

Comments to this Manuals

No comments

Delta 36-5000 Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-5000