Delta 36-5000 Instruction Manual download pdf (Page 24)

100

RIP CUTS

1. Remove miter gauge

2. Make sure bevel angle is set to 0°.

3. Set blade to correct height for workpiece.

4. Install rip fence and lock it down parallel with and

at desired distance from blade.

5. Keep fingers at least 6 inches from the blade at

all times. When the hand cannot be safely put

between the blade and the rip fence, select a

larger workpiece, or use a push stick and other

cutting aids, as needed, to control the workpiece.

6. Make sure the workpiece is clear of the blade (at

least 1 inch or 25mm away) before starting the

saw

7. Turn saw on.

8. Hold the workpiece flat on the table and against

the fence (A). The workpiece must have a straight

edge against the fence and must not be warped,

twisted or bowed. See proper hand position in

Figure 24.

9. Let blade build up to full speed before moving

workpiece into the blade.

10. Both hands can be used while starting the cut as

long as hands remain 6 inches from the blade.

11. Keep the workpiece against the table and fence

and slowly feed the workpiece rearward all the

way through the saw blade. Do not overload the

motor by forcing the workpiece into the blade.

OPERATION

(continued)

BEVEL RIPPING

Bevel ripping is the same as ripping except the

bevel angle (A) is set to an angle other than 0°.

When making a bevel rip cut, place the fence on

the right side of the blade so that the blade is tilted

away from the fence and hands.

12. Use the push stick and any other cutting aids,

as needed, to hold the workpiece against the

table and fence, and push the workpiece past the

blade. A push stick is included with this saw, and

instructions are included to make additional push

sticks and other cutting aids.

13. Do not push or hold onto the free or cut-off side of

the workpiece.

14. Continue pushing the workpiece until it is clear of

the blade. Do not overload the motor by forcing the

workpiece into the blade.

15. When cut is complete, turn saw off. Wait for blade

to come to a complete stop before removing

workpiece from table.

FIGURE 25

FIGURE 24

45º

0º

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 99 100

Comments to this Manuals

No comments

Delta 36-5000 Instruction Manual Page 24

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-5000