Delta 36-5000 Instruction Manual download pdf (Page 31)

ALIGNING FENCE PARALLEL TO

MITER SLOT

1. Move fence adjacent to right miter gauge and

secure to the guide tube by lowering the fence

clamping lever.

2. If the fence face (A) figure 39, is not parallel to the

miter slot (B), raise the clamping lever and lift the

fence and place it on the saw table.

3. Adjust the one or both of the set screws (C) 1/4

turn or less.

4. Replace fence on guide tube and repeat steps 1

through 3. If fence is closer to parallel, turn the set

screw in the same direction but a little less. If the

fence is further out of parallel, turn the set screw in

the opposite direction.

5. Repeat steps 1 through 3.

ALIGNING FENCE

PERPENDICULAR TO THE

TABLE

1. Move fence over the cast iron table and secure

to the guide tube by lowering the fence clamping

lever.

2. Use a square to check that the fence face is

perpendicular to the table.

3. If the fence face is not perpendicular to the table,

release the clamping lever and slightly adjust one

of the slotted set screws (A) figure 40 until the

fence face is perpendicular to the table.

4. Secure the fence to the guide tube to insure the

fence remains perpendicular. If not, repeat steps 1

through 4.

FIGURE 39 FIGURE 40

ALIGNMENT

(continued)

240 VOLT SINGLE PHASE OPERATION

The 120/240 volt, dual-voltage motor supplied with your machine was shipped prepared for 120 volt operation.

It can be converted for 240 volt operation. For conversion from 120 volt to 240 volt, please call ahead to DELTA

Customer Care at 1-800-223-7278.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

No comments

Delta 36-5000 Instruction Manual Page 31