Delta 36-5000 Instruction Manual download pdf (Page 32)

100

ACCESSORIES

A complete line of accessories is available from your DELTA

Supplier, DELTA

Factory Service Centers,

and DELTA

Factory Service Centers, and DELTA

Authorized Service Centers. Please visit our Web Site

www.DeltaMachinery.com for an online catalog or for the name or your nearest supplier.

Since accessories other than those offered by DELTA

have not been tested with this product,

use of such accessories could be hazardous. For safest operation, only DELTA

recommended

accessories should be used with this product.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers

or call DELTA® Power Equipment Customer Care at 1-800-223-7278.

FAILURE TO START

If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the

receptacle, and check reset button on power switch housing. Also, check for blown fuses or open circuit breakers in

your power line.

MAINTENANCE REMINDERS

Wear certified safety equipment for eye, hearing and

respiratory protection while using compressed air.

Specific areas which require regular maintenance

include:

RIVING KNIFE CLAMP PLATE: Keep this area free of

dust and debris buildup. Blow out area regularly with

compressed air.

NOTE: If the riving knife clamp can't move freely,

have the saw serviced by authorized DELTA

Power

Equipment Corporation service center personnel.

WORM GEARS: Keep the worm gears free of dust

and debris buildup. Blow out area regularly with

compressed air. Use a lithium-based multipurpose

grease as needed on these gears.

CLEAN SAWDUST BUILDUP OUT OF CABINET

PERIODICALLY: NOTE: Debris can also be removed

from the saw from below the throat plate, inside the

dust port.

MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before

installing and removing accessories, before adjusting and when making repairs. An accidental start-up can cause

injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry

compressed air. All plastic parts should be cleaned

with a soft damp cloth. NEVER use solvents to clean

plastic parts. They could possibly dissolve or otherwise

damage the material.

Wear certified safety equipment for eye, hearing and

respiratory protection while using compressed air.

LUBRICATION & RUST PROTECTION

Apply hardwood flooring paste wax to the machine

table occasionally or use a commercially available

protective product designed for this purpose. Follow

the manufacturer’s instructions for use and safety.

To clean cast iron tables of rust, you will need the

following materials: a medium sized scouring pad, a

can of spray lubricant and a can of degreaser. Apply

the spray lubricant and polish the table surface with

the scouring pad. Degrease the table, then apply the

protective product as described above.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Comments to this Manuals

No comments

Delta 36-5000 Instruction Manual Page 32

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-5000