Delta 36-600 User Manual

PART NO. 1349943 DATED 06-01-01INSTRUCTION MANUALT-Square®UniversalHome ShopFence System®

ASSEMBLING TABLE ASSEMBLY TO FRONT AND REARRAILS1. Place table assembly (A) in position between the front and rear rails, as shown in Figs. 20 and 21.

ASSEMBLING GUIDE TUBE TO FRONT RAILFOR ALL SAWS1. Lay the guide tube (D) Fig. 23, on saw table as shown, and line up the threaded holes (M) on bottom

FENCE OPERATIONIMPORTANT: Before operating fence, make sure the fence is adjusted parallel to the miter gage slot, as explainedlater on in this manual

IMPORTANT: Check to make certain that the miter gageslots in the saw table are parallel with the saw bladebefore adjusting the fence parallel to the m

When the fence locking handle (A) is pushed to the downposition, as shown in Fig. 31, the fence assembly (B) shouldbe completely clamped to the guide

PARTS, SERVICE, OR WARRANTY ASSISTANCETo obtain additional information regarding this product or to obtain parts, service or warranty assis-tance, ple

INTRODUCTIONThe models 78-930, 28” capacity; 78-931, 40” capacity; and 78-935, 52” capacity Universal T-Square® Fence Sys-tems include the fence as

5 – Template for aligning front rail to saw table6 – Cable Strap7 -- *Switch bracket for use with Delta 10” Contractor’s Saws and Delta 10” Contr

If you purchased the accessory right extension table, carefully unpack the extension table from the shipping container.Figure 4 illustrates the access

ASSEMBLY INSTRUCTIONSWhen mounting the T-Square® Fence System to table saws that have been equipped with original equipment fence, guiderails and open

FOR ALL SAWS(Including Delta Models 34-67-, 34-380 and 36-600)5. Using the template (G) Figures 8 and 9, check andadjust front rail (C) at both sides

FOR DELTA TABLE SAWS(Except Models 34-670, 34-380 and 36-600)10. Align the two non-countersunk hole (K) Fig. 12, of rearrail (L) with the two holes in

CONSTRUCTING EXTENSION TABLE1. If you did not purchase the accessory right extension table for use with your T-Square® Fence,construct an extension ta

DFBCFEFAFig. 18Fig. 172. Replace the two legs and fasten to the bottom of thetable using the eight 5/8” long wood screws (B) supplied.3. Fasten the le