Delta 36-902 Instruction Manual download pdf (Page 12)

ASSEMBLING FENCE TO

UNIFENCE BODY

1. The fence (A) can be assembled to clamp plate (B) in

either the horizontal position as shown in Fig. 38, or the

vertical position as shown in Fig. 39. Make certain the

two lock knobs (C), are loose and slide fence (A) onto

clamp plate (B) as shown. Then tighten the two lock

knobs (C).

2. For most normal ripping operations, the bottom of

the fence should be positioned slightly above the table

surface. Loosen two lock knobs (C) Fig. 40, and place a

thin object such as a scale (D) between the table and

fence, as shown. Then tighten two lock knobs (C).

Fig. 38

Fig. 39

Fig. 40

FENCE OPERATION

Fig. 41

1. Before operating fence, make sure the fence is ad-

justed parallel to miter gage slot, as explained later on in

this manual.

2. For most normal ripping operations of standard size

lumber, the fence is used in the vertical position, as

shown in Fig. 41.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 36-902 Instruction Manual Page 12