Delta 36-902 Instruction Manual download pdf (Page 13)

3. When ripping thin stock, it is sometimes more

convenient to use the fence in the horizontal position, as

shown in Fig. 42.

4. To move the fence along the guide rail, lift up clamp

lever (A), as shown in Fig. 43, slide fence to desired

position on the rail, and push down on clamp lever (A) to

lock fence in place.

5. The distance the fence is positioned away from the

blade is indicated by the two witness lines (B) and (C) Fig.

44, located on the cursor (D). Witness line (B) indicates

the distance the fence is away from the blade when the

fence is in the horizontal position, and witness line (C)

indicates the distance the fence is away from the blade

when the fence is in the vertical position. If it is necessary

to adjust cursor (D), make a test cut with the fence in

either the vertical or horizontal position, measure the

distance of the finished cut and move the cursor (D) by

loosening the two screws (E) Fig. 44. After adjustment is

completed tighten the two screws (E).

6. To remove the fence and fence body assembly (F)

Fig. 45, from the guide rail, lift up on fence clamping lever

(A) and turn lever (A) counterclockwise to the left indent

position. The fence assembly (F) can then be pulled

straight off the guide rail and removed.

Fig. 42

Fig. 43

Fig. 44

Fig. 45

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 36-902 Instruction Manual Page 13