Delta 36-902 Instruction Manual download pdf (Page 15)

Fig. 50

Fig. 51

Fig. 52

Fig. 53

ADJUSTING FENCE PARALLEL

TO MITER GAGE SLOTS

The fence (A) Fig. 50, should be adjusted so it is parallel

to miter gage slots (B). To check and adjust, move the

fence (A) until the bottom front edge of the fence is in line

with the edge of the miter gage slot as shown, and push

down on fence clamping lever (C). Check to see if the

fence is parallel to the miter gage slot the entire length of

the table. If the rear of the fence must be moved, slightly

tighten or loosen one of the adjustment plugs (D) or (E)

Fig. 50, using the arbor wrench or a 7/8" wrench, until the

fence is parallel with the miter gage slot. IMPORTANT:

DO NOT OVER-TIGHTEN PLUGS (D) AND (E) FIG. 50.

VERY LITTLE MOVEMENT OF THESE PLUGS IS

NECESSARY WHEN ADJUSTING THE FENCE

PARALLEL WITH THE MITER GAGE SLOT.

ADJUSTING FENCE 90

DEGREES TO TABLE

The fence must be adjusted so that the face of fence (A)

Fig. 51, is 90 degrees to the table. To check if the fence

is 90 degrees to the table, place a square (B) on the table

with one end of the square against the fence, as shown.

If an adjustment is necessary, tighten or loosen one of

two screws (C) or (D) until the fence is 90 degrees to the

table.

IMPORTANT: VERY LITTLE MOVEMENT OF THESE

SCREWS (C) AND (D) IS NECESSARY TO MAKE THIS

ADJUSTMENT.

ADJUSTING CLAMPING

ACTION OF FENCE

LOCKING HANDLE

When the fence locking handle (A) is pushed to the down

position, as shown in Fig. 52, the fence body (B) should

be completely clamped to the guide rail. If the fence body

(B) is not completely clamped to the guide rail when the

handle (A) is in the position shown in Fig. 52, lift up on

locking handle (A) Fig. 53, and slightly tighten two

adjustment plugs (C) using the arbor wrench or 7/8"

wrench. Adjustment plugs (C) should be tightened an

equal amount. Check to see if the fence body (B) is

completely fastened to the rail by pushing down on

locking lever (A). Adjust further if necessary.

IMPORTANT: AFTER ADJUSTING THE CLAMPING

ACTION OF THE FENCE LOCKING HANDLE, CHECK

TO SEE IF THE FENCE IS PARALLEL TO THE MITER

GAGE SLOT AND ADJUST IF NECESSARY.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Delta 36-902 Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-902