Delta 36-902 Instruction Manual download pdf (Page 2)

INTRODUCTION

The model 36-902, 30" capacity Unifence

™

Saw Guide can be assembled to the, Contractors Saw and Unisaw, in

addition to other makes of table saws. The 36-902 Unifence Saw Guide includes the fence, carriage assembly, front

guide rail, table frame and legs. The accessory 36-893 table for the 36-902 30" Unifence, is not included and must be

ordered separately or a similar table must be constructed by following the instructions in this manual.

UNPACKING

Carefully unpack the Unifence and all loose items from the shipping cartons.

Fig. 1

1. Rail

2. Front Table Support Bracket (1)

3. Fence

4. Unifence Body

5. Table leg Support Bracket

6. Table Adapter Plate

7. Table Leg (2)

8. Rear table support bracket

9. 1/4-20x2" Flip stop bolt

10. Flip stop bracket

11. 5/16-18x1" Hex head bolt

12. Flip stop

13. Flip stop knob

14. 1/4-20 Nut

15. Flip stop fiber washer (2)

16. Unifence cursor

17. Angle bracket (5)

If you purchased the Unifence without the table, a table must be constructed, as follows:

1. A 32" long by 27" wide table is constructed using 3/4" material by following the dimensions shown in Fig. 2.

2. Three undercuts must also be made on the bottom left end of the table. The location and size of the undercuts are

shown in detail in Figs. 2 and 3.

3. IMPORTANT: For maximum ease when sliding the fence across the table we suggest that the top of the table be

covered with a veneer.

CONSTRUCTING UNIFENCE TABLE AND SHELF

1 2 3 4 5 6 7 ... 19 20

No comments

Delta 36-902 Instruction Manual Page 2