Delta 36-902 Instruction Manual download pdf (Page 4)

ASSEMBLING TABLE

TO SAW

1. If your saw has a right extension wing, front and rear

guide rails, they must be removed.

2. Lay the table upside down on the floor or bench, as

shown in Fig. 4.

3. Assemble the two table legs (A) Fig. 5 to the bottom

of the table using eight #8x7/8" self tapping screws

supplied. NOTE: Refer to Fig. 2 for the hole location for

the 36-902 30" Unifence.

Fig. 4

Fig. 5

4. Insert foot adapter (T) Fig. 6, into the bottom of each

leg (A). Assemble the 3/8" jam nut (V) approximately 3/4

of the way onto leveling screw (W). Thread the leveling

screw (W) into foot adapter. Fig. 7 illustrates the foot

leveling assembly on the table leg. Assemble the

remaining foot assembly to the other table leg in the

same manner. NOTE: Height adjustments can be made

later.

Fig. 6

Fig. 7

Fig. 8

4. Assemble table leg support bracket (B) Fig. 8, to the

table legs (A) using two U-clamps (C), flat washers, and

hex nuts.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Delta 36-902 Instruction Manual Page 4