Delta 36-902 Instruction Manual download pdf (Page 5)

5. Fasten the front table support (F) Fig. 9, to the

bottom of the table as shown using two #8x7/8" long

wood screws (H) and (I) supplied.

NOTE: The vertical flange, on the table board support

(F), should be flush with the front edge of the table

board.

NOTE: The slots closer to the angles in the support (F)

should be against the table.

NOTE: Screws (H) and (I) Fig. 9 should not be

completely tightened to the table board at this time.

Screw (I) will have to be removed later.

NOTE: Make certain the end of the table support does

not extend out past the table.

CAUTION: DO NOT OVER-TIGHTEN MOUNTING

SCREWS. Over-tightening screws in particle board may

cause them to strip.

FOR UNISA

WS ONL

6. Fasten the rear table support (A) Fig. 10, to the saw

table. Insert a 3/8-24x5/8" hex head screw (B), through hole

in rear support and thread screw into tapped hole in table.

Repeat this process for the remaining hole. Tighten screws

securely. NOTE: FLAT EDGE (D) Fig. 10 AND FIG. 10A, OF

REAR TABLE SUPPORT WILL FACE UPWARD.

FOR 10" CONTRACTORS SA

WS ONLY

6. Fasten the rear table support (A) Fig. 10, to the saw

table. Insert a 3/8-16x1" hex head screw (B), through hole in

rear support and table, place a 3/8 washer onto the screw

and thread a 3/8-16 hex nut onto screw and tighten

securely. Repeat this process for the remaining hole. NOTE:

FLAT EDGE (D) Fig. 10 AND FIG. 10A, OF REAR TABLE

SUPPORT WILL FACE UPWARD.

7. If your saw is equipped with a cast iron wing as shown

at (I) Fig. 10. which has a smooth surface, hole (C) Fig. 10 is

not used, proceed to step 8. If your saw has a sheet metal

wing as shown at (W) Fig. 10A, with a ribbed surface, the

rear table support will be fastened through hole (C) Fig. 10A

as follows. Insert a 3/8-16x1" hex head screw through hole

on the screw, thread a 3/8-16 hex nut on screw, and tighten

securely.

FOR ALL T

ABLE SAWS

8. Assemble the three brackets (J) to the table adapter

plate (K) using the three 1/4-20x3/4" carriage bolts, nuts and

washers, as shown in Fig. 11. NOTE: The long leg of the

brackets (J) should be against the adapter plate (K) as

shown. Do not completely tighten brackets (J) to adapter

plate (K) at this time.

Fig. 9

Fig. 11

Fig. 10

Fig. 10A

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Delta 36-902 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Circular saws Delta 36-902