Delta 36-902 Instruction Manual download pdf (Page 7)

Fig. 17

13. Using a straight edge (S) Fig. 17, make certain the

Unifence table surface is level with the saw table by

adjusting two leveling screws located on the bottom of

table legs and adjusting angle brackets (B) Fig. 13, use

a level, side to side and front to back to make sure the

table is level. IMPORTANT: Front edge of Unifence table

must be flush with or slightly behind front edge of saw

table.

Fig. 16

12. Assemble the table (A) to the two brackets (J) on

the rear table support (K) Fig. 16, using two #8x7/8"

screws.

ASSEMBLING UNIFENCE

GUIDE RAIL TO A SAW

WITH A LEFT SIDE SHEET

METAL EXTENSION WING

When mounting a 36-902 Unifence to a saw with a left

side sheet metal wing, if the ON/OFF switch is mounted

to the extension wing proceed with step #1 if not

proceed to step #2.

1. Remove the screw (A) Fig. 18 that attaches the

ON/OFF switch to the sheet metal wing. Insert a 3/8-

16x1¼" hex head screw through the sheet metal wing

and the ON/OFF switch bracket and place a 3/8" washer

onto the screw, and thread a 3/8-16 hex nut onto the

bolt, do not tighten the nut at this time. NOTE: LEAVE

THE HEX HEAD BOLT EXTENDED OUT THE FRONT

OF THE SHEET METAL WING, THE GUIDE RAIL WILL

BE ATTACHED TO THE END OF THE HEX HEAD

SCREW.

2. Insert a 3/8-16x1¼" hex head screw (A) Fig. 19

through the sheet metal wing and place a 3/8" washer

onto the screw, and thread a 3/8-16 hex nut onto the

bolt, do not tighten the nut at this time. NOTE: LEAVE

THE HEX HEAD BOLT EXTENDED OUT THE FRONT

OF THE SHEET METAL WING, THE GUIDE RAIL WILL

BE ATTACHED TO THE END OF THE HEX HEAD

SCREW.

Fig. 18

Fig. 19

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Delta 36-902 Instruction Manual Page 7