Delta 78-955 Instruction Manual download pdf (Page 5)

5. Locate two bushings each, (K) and (L) Fig. 8, two

1/4-20 x 5/8” button head screws (M); two 5/16-18 x 5/8”

button head screws (N ) and splitter mounting bracket

assembly (P). NOTE: Bushings (K) with smaller I.D.

hole and two 1/4 x 5/8” long screws (M) are used when

mounting the splitter to the Delta 10” tilting arbor saw

and the 10” Contractors saw. Bushings (L) Fig. 14,

with the larger I.D. holes and two 5/16-18 x 5/8” long

button head screws (N) are used when mounting the

splitter bracket to a 10” Unisaw.

6. Depending on what saw you are using, insert bushings

(K or L) Fig. 8, into holes (Q) in the splitter mounting

bracket.

7. Remove the saw blade from the saw arbor.

8. Assemble the splitter mounting bracket (P) Fig. 9, to

the inside of rear trunion using two button head screws (N)

Figs. 8 and 9, since we are mounting the splitter to a 10”

Left tilting Arbor Unisaw. NOTE: Just snug up button head

screws at this time.

9. Using a straight edge (R) Fig. 10, align the top portion

of splitter mounting bracket (P) to saw arbor (S) as shown.

Then tighten two screws (N) Fig. 9.

Fig. 7

Fig. 8

Fig. 9

Fig. 10

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 78-955 Instruction Manual Page 5