Delta 78-955 Instruction Manual download pdf (Page 6)

Fig. 11

Fig. 12

Fig. 13

Fig. 14

10. Insert index pin (T) Fig. 11, through the hole in splitter

(U), as shown, and fasten with locknut (V). Fig 11 illustrates

the index pin assembly arrangement for both right and left

tilting arbor saws.

11. Loosen knob (F) Fig. 12, and slide splitter (U) down as

far as possible into the splitter mounting bracket and tighten

knob (F). Fig 13 illustrates the splitter assembled to the

mounting bracket. IMPORTANT: When performing non

thru-cutting operations, such as dadoing, the splitter (U)

Figs. 12 and 13, can be removed by loosening knob (F).

This enables you to use the guard basket for non

thru-cutting operations.

GUARD ASSEMBLY

12. Clamp the guard mounting bracket (A) Fig. 14 to the

back rail (B) of the fence system, making sure the inside of

the vertical post (C), is approximately 1/4” past the end of

rail (B).

13. Using a 9/32” drill bit, drill six holes in the rear rail, three

each to be drilled into the horizontal and vertical portion of

the back rail (B), using the holes (D) and (E) in the mounting

bracket as a template.

LEFT-TILT

RIGHT-TILT

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 78-955 Instruction Manual Page 6