Delta OILLUBE AIR COMPRESSOR DLKC6580V2 User Manual download pdf (Page 10)

10-ENGD25235

1. Place the air compressor on on a

solid, level surface.

2. Mark the surface using the holes

in the air compressor feet as a

template.

3. Drill holes in the surface for the

concrete anchors. Install con-

crete anchors.

4. Line-up holes in surface with

holes in air compressor feet.

5. Place the (4) washers (not sup-

plied) between the floor and air

compressor feet. If needed, solid

shims may be placed between

the washers and floor to evenly

distribute weight on all four feet.

See next figure.

6. Place the (4) 3/8" lag screws

through the air compressor feet,

washers, shims, and into the

anchors.

7. Torque 3/8" lag screws to 7-10

ft.-lbs.

Anchoring of the Air

Compressor

Excessive Vibration

can weaken the air

tank and cause an explosion. The

compressor must be properly

mounted.

The air compressor MUST be bolted

to a solid, level surface.

Hardware needed:

4 - Concrete anchors (not sup-

plied)

4 - 3/8" Lag screw to fit con-

crete anchors (not supplied)

4 - 5/8" Washer (not supplied)

- Shims (if needed)

Location of the Air Compressor

• Locate the air compressor in a

clean, dry, and well ventilated

area.

• Locate the air compressor at

least 12" away from the wall or

other obstructions that will inter-

fere with the flow of air.

• Locate the air compressor as

close to the main power supply

as possible to avoid using long

lengths of electrical wiring.

NOTE: Long lengths of electrical

wiring could cause power loss to

the motor.

• The air filter must be kept clear

of obstructions which could

reduce air flow to the air com-

pressor.

HOW TO SET UP YOUR UNIT

3/8" Lag

Screw

(not supplied)

5/8" Washer

(not supplied)

Shim Under

Washer

(not supplied)

Concrete Anchor

(not supplied)

Surface Line

INSTALLATION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments