Delta OILLUBE AIR COMPRESSOR DLKC6580V2 User Manual download pdf (Page 21)

21-ENG D25235

Motor

This motor has a manual thermal

overload protector. If the motor over-

heats for any reason, the overload

protector will shut off the motor. The

motor must be allowed to cool down

before restarting. To restart:

1. Place the On/Auto/Off lever in

the Off position.

2. Allow the motor to cool.

3. Depress the red reset button on

the motor.

Additional Service

Disassembly or service of the air

compressor beyond what is covered

in this manual is not recommended. If

additional service is required, contact

your nearest Authorized Warranty

Service Center.

Reset

Button

4. Place the On/Auto/Off lever in

the On/Auto postion to restart

the motor.

IMPORTANT: If the overload protec-

tor shuts the motor off frequently,

check for a possible voltage problem.

Low voltage can also be suspected

when:

1. The motor does not get up to full

power or speed.

2. Fuses blow out when starting the

motor; lights dim and remain dim

when motor is started and is run-

ning.

STORAGE

Before you store the air compressor,

make sure you do the following:

1. Review the "Maintenance" sec-

tion on the preceding pages and

perform scheduled maintenance

as necessary.

2. Set the On/Auto/Off lever to

"OFF".

3. Close the globe valve.

4. Remove the air tool or accessory.

5. Open the globe valve and allow

the air to slowly bleed from the

air tank until tank pressure is

approximately 20 psi.

6. Drain water from air tank by

opening drain valve (counter-

clockwise) on bottom of tank.

Water will condense

in the air tank. If

not drained, water will corrode and

weaken the air tank causing a risk

of air tank rupture.

7. After the water has been drained,

close the drain or drain valve.

NOTE: If drain valve is plugged,

release all air pressure. The valve can

then be removed, cleaned, then

reinstalled.

8. Protect the air hose from damage

(such as being stepped on or run

over).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Comments to this Manuals

No comments