Delta ShopMaster CP200 User Manual download pdf (Page 11)

11- ENG

D27930

OPERATION

Know Your Air Compressor

READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING

YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with

the location of various controls and adjustments. Save this manual for future

reference.

Description of Operation

Become familiar with these controls before operating the unit.

Auto/On/Off Switch: Set switch

in AUTO/ON position to provide

automatic power to the pressure

switch and OFF to remove power

at the end of each use.

Pressure Switch (not shown):

The pressure switch automatically

starts the motor when the air tank

pressure drops below the factory

set "cut-in" pressure. It stops the

motor when the air tank pressure

reaches the factory set "cut-out"

pressure.

Safety Valve: If the pressure

switch does not shut off the air compressor at its "cut-out" pressure setting,

the safety valve will protect against high pressure by "popping out" at its

factory set pressure (slightly higher than the pressure switch "cut-out" setting).

Outlet Pressure Gauge: The outlet pressure gauge indicates the air pressure

available at the outlet side of the regulator. This pressure is controlled by the

regulator and is always less than or equal to the tank pressure.

Tank Pressure Gauge: The tank pressure gauge indicates the reserve air

pressure in the tank.

Regulator: Controls the air pressure shown on the outlet pressure gauge. Pull

the knob out and turn clockwise to increase pressure and counterclockwise to

decrease pressure. When the desired pressure is reached push knob in to lock

in place.

Drain Valve: The drain valve is located at the base of

the air tank and is used to drain condensation at the

end of each use.

Cooling System (not shown): This compressor

contains an advanced design cooling system. At the

heart of this cooling system is an engineered fan. It is

perfectly normal for this fan to blow air through the vent holes in large

amounts. You know that the cooling system is working when air is being

expelled. NOTE: It is normal for the fan to run continuously when the unit is in

the "ON" position. To turn the fan off, switch the unit to the "OFF" positon.

Air Compressor Pump (not shown): Compresses air into the air tank.

Working air is not available until the compressor has raised the air tank

pressure above that required at the air outlet.

Check Valve (not shown): When the air compressor is operating, the check

valve is "open", allowing compressed air to enter the air tank. When the air

compressor reaches "cut-out" pressure, the check valve "closes", allowing air

pressure to remain inside the air tank.

Tank

Pressure

Gauge

Outlet

Pressure

Gauge

Regulator

Safety

Valve

Drain

Valve

Auto/On/Off

Switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Delta ShopMaster CP200 User Manual Page 11

Comments to this Manuals

Related products and manuals for Conditioners Delta ShopMaster CP200