Delta ShopMaster CP200 User Manual download pdf (Page 15)

15- ENG

D27930

Performing repairs may expose voltage sources, moving

parts or compressed air sources, moving parts or

compressed air sources. Personal injury may occur. Prior to attempting

any repairs, unplug the air compressor and bleed off all air tank air

pressure.

PROBLEM

CAUSE

CORRECTION

Compressor does not turn

off when compressor

reaches "cut-out" pressure.

Pressure switch "cut-out"

too high.

Set Auto/On/Off switch to

the "OFF" position, if the

unit does not shut off contact

a Trained Service Technician.

Contact a Trained Service

Technician.

Excessive tank

pressure - safety

valve pops off.

Tube fittings are not tight

enough.

Using a soapy water solution

check all exposed fittings for

leaks. If needed reseal

fittings with pipe sealant

tape and retighten securely.

Do Not Overtighten. If

leaks continue contact a

Trained Service Technician.

Air leaks at

fittings.

Air leaks in air

tank or at air

tank welds.

Defective air tank. Air tank must be replaced.

Do not repair the leak.

Do not drill into, weld or

otherwise modify air tank

or it will weaken. The tank

can rupture or explode.

TROUBLESHOOTING

Low voltage Extension cord is wrong

length or gauge. Check

extension cord.

Thermal

overload

protector cuts

out repeatedly

Improper ventilation/

temperature too high

Operate compressor in a

well ventilated area.

Defective check valve

Contact a Trained Service

Technician

Defective valves

Contact a Trained Service

Technician

It is normal for the fan to run

continuously when the unit

is in the "ON" position.

To stop fan, Turn the

Auto/On/Off switch to the

"OFF" position.

Fan continues

to run when

Auto/On/Off

switch is in the

"ON" position.

1 2 ... 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Delta ShopMaster CP200 User Manual Page 15

Comments to this Manuals

Related products and manuals for Conditioners Delta ShopMaster CP200