Delta ShopMaster CP200 User Manual download pdf (Page 8)

8- ENG

D27930

GLOSSARY

Become familiar with these terms before operating the unit.

CFM: Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of measure of air delivery.

PSIG: Pounds per square inch gauge; a unit of measure of pressure.

Code Certification: Products that bear one or more of the following marks:

UL, CUL, ETL, CETL,

CSA/US

have been evaluated by OSHA certified

independent safety laboratories and meet the applicable Underwriters

Laboratories Standards for Safety.

CSA: Electrical products sold in Canada are required to be certified to the

applicable CSA standard (s). Canadian Standards Association (CSA) is a

standards writing and safety testing organization. Products that are CSA

certified have been evaluated and tested and found to meet or exceed the

applicable CSA standard (s) for safety and electrical performance.

Cut-In Pressure: While the motor is off, air tank pressure drops as you

continue to use your accessory. When the tank pressure drops to a certain low

level the motor will restart automatically. The low pressure at which the motor

automatically restarts is called “cut-in” pressure.

Cut-Out Pressure: When an air compressor is turned on and begins to run,

air pressure in the air tank begins to build. It builds to a certain high pressure

before the motor automatically shuts off - protecting your air tank from

pressure higher than its capacity. The high pressure at which the motor shuts

off is called “cut-out” pressure.

Branch Circuit: Circuit carrying electricity from electrical panel to outlet.

Model No. CP200

Voltage/Hertz/ Phase 120V/60/1

Minimum Branch Circuit Requirement 15 amps

*Fuse Type Time Delay

Air Tank Capacity 2 gallons

Approximate Cut-in Pressure 75 PSI

Approximate Cut-out Pressure 100 PSI

SPECIFICATIONS

* A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same

rating as the branch circuit on which the air compressor is operated. If

compressor is connected to a circuit protected by fuses, use only time delay

fuses. Time delay fuses should be marked “D” in Canada and “T” in the US.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Delta ShopMaster CP200 User Manual Page 8