Delta 36-240 Instruction Manual download pdf (Page 13)

Fig. 34

Fig. 35

Fig. 36

Fig. 37

ADJUSTING SLIDING FIT

BETWEEN MOVABLE

TABLE AND BASE

When it becomes necessary to adjust the sliding fit

between the movable table and the base proceed as

follows: Turn nut (A) Fig. 34, clockwise to increase or

counterclockwise to decrease the sliding fit. This

adjustment should not be too tight that it restricts the

rotating movement of the table or too loose that it

affects the accuracy of the saw.

ADJUSTING FENCE

90 DEGREES TO BLADE

IMPORTANT: BEFORE MAKING THIS ADJUSTMENT,

MAKE CERTAIN THE BLADE IS SET AT 90 DEGREES

TO THE TABLE. SEE SECTION “ADJUSTING 90 AND

45 DEGREE BEVEL POSITIVE STOPS.”

1. DISCONNECT THE TOOL FROM THE POWER

SOURCE.

2. Rotate the table so that the blade is 90 degrees to

the fence and the spring-loaded positive stop for the 0

degree mark on the scale is engaged.

3. Using a square (A) Fig. 35, place one end of the

square against the fence (B) and the other end against

the blade as shown. Check to see if the fence is 90

degrees to the blade.

4. If an adjustment is necessary, the fence (B) can be

adjusted by loosening the two screws, one of which is

shown at (C) Fig. 35, that attach the fence to the base,

using wrench (D) supplied. Adjust the fence (B) as

required and tighten two screws (C).

5. After you are sure the fence is 90 degrees to the

blade, adjust the two cursors, one of which is shown at

(E) Fig. 36, so the pointer is aligned with the 0 degree

mark on the scale by loosening screw (F), adjusting

cursor (E) and tightening screw (F).

TABLE HAZARD AREA

WARNING: THE AREA INSIDE THE RED LINE (A)

FIG. 37, ON THE TABLE IS DESIGNATED AS A

HAZARD ZONE. NEVER PLACE YOUR HANDS

INSIDE THIS AREA WHILE THE TOOL IS BEING

OPERATED.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Comments to this Manuals

No comments

Delta 36-240 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Cordless chainsaws Delta 36-240