Delta 36-240 Instruction Manual download pdf (Page 14)

Fig. 38

Fig. 39

Fig. 40

Fig. 41

WORK CLAMP OPERATION

1. The height of the work clamp (A) Fig. 38, can be

adjusted by loosening lock knob (B) and moving post (C)

up or down, or compressing lock lever (D) and sliding

clamp body (E) up or down. After height of clamp (A)

is adjusted, tighten lock knob (B) and/or release lock

lever (D).

2. During operation, lower clamp (A) Fig. 39, until the

bottom of the clamp (A) lightly contacts top of workpiece

(F). IMPORTANT: When lowering clamp (A) make

certain cam lever (G) is in the up position as shown.

3. For final clamping of the workpiece (F) Fig. 40,

against the table, move cam lever (G) to the rear, as

shown. After cut is completed, lift lever (G). This will

raise clamp (A) slightly, allowing you to slide or remove

workpiece (F).

TILTING CUTTINGHEAD

FOR BEVEL CUTTING

The cuttinghead of your compound slide saw can be

tilted to cut any bevel angle from a 90 degree straight

cut-off to a 45 degree left bevel angle by loosening bevel

lock knob (A) Fig. 41, tilting cuttinghead (B) to the desired

angle, and tightening lock knob (A).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 32 33

No comments

Delta 36-240 Instruction Manual Page 14