Delta 36-240 Instruction Manual download pdf (Page 25)

Fig. 72

REPLACING SAW

ON STAND

(FOR MODEL 36-250 ONLY)

When assembling the stand to the saw, reverse the

instructions listed in the section “REMOVING SAW

FROM STAND” and keep in mind that the distance

between the center of screw (A) Fig. 72, and bent hinge

screw (B) MUST BE 8

″″

and the distance between the

center of screw (C) and straight hinge screw (D) MUST

BE 8-1/2

″″

OPERATION

CORRECT OPERATING PROCEDURE FOR SLIDE CUTTING

WARNING: SLIDE CUTTING BY PULLING THE SAW TOWARDS THE OPERATOR CAN BE

DANGEROUS, CAUSING THE SAW TO KICK UPWARDS AND TOWARDS THE OPERATOR. ALWAYS

PUSH THE SAW FORWARD, AWAY FROM THE OPERATOR, AND TOWARDS THE FENCE WHEN SLIDE

CUTTING.The following steps illustrate the proper operating procedure to follow when slide cutting with your

compound slide saw. NOTE: Operational illustrations are shown using the slide saw on a work bench using

2 x 4 extensions.

Fig. 73

Fig. 74

1. Place the workpiece (A) on the table and against the

fence, as shown in Fig. 73. Grasp the cuttinghead

handle (B) but do not turn the saw on at this time.

2. Pull the cuttinghead (C) Fig. 74, toward you, with the

cuttinghead in the up position. After the cuttinghead is

pulled toward you, compress switch trigger to turn the

saw on, as shown.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

No comments

Delta 36-240 Instruction Manual Page 25