Delta 36-240 Instruction Manual download pdf (Page 7)

Fig. 7

Fig. 8

Fig. 9

Fig. 11Fig. 10

3. Pivot the machine so feet (D) Fig. 7, of the left leg are

on the floor. NOTE: Make certain the leg hinges (C) Fig.

7, are locked in place before raising the machine to an

upright position.

4. Raise the right side of the machine and unfold right

leg (A) Fig. 8. Lock right leg (A) in position by pushing

hinges (E) inward.

5. Loosen four lock knobs on leg assemblies, two of

which are shown at (F) Fig. 8.

6. With foot on lower brace (G) Fig. 9, lift up table

extension (H) so upper leg (J) extends out from lower leg

(K) and protrusions (L) Fig. 10, snap in and engage with

round holes in upper legs (J). This locks the upper and

lower legs (J) and (K) in position. Tighten two locking

knobs (F) Fig. 10.

7. Pull right side upper leg (L) Fig. 11, from lower leg (K)

in the same manner. Tighten the remaining two locking

knobs (F). CAUTION: Make certain both legs are fully

extended and locked in position before operating the

saw.

1 2 3 4 5 6 7 8 9 10 11 12 ... 32 33

No comments

Delta 36-240 Instruction Manual Page 7