Delta 36-729 User Manual download pdf (Page 4)

444

REAR GUIDE RAIL

1. Align the holes in the rear guide rail with the holes in

the back of the saw table.

FOR MODEL 36-729 ONLY

2. Insert a 3/8-24x1-1/4" hex head screw (A) Fig. 7,

with a 3/8" lockwasher through the hole in the rear guide

rail and thread the screw into the tapped hole in the

back of the saw table. Repeat this process for the

remaining hole in the rear guide rail and the saw table.

FOR TABLE SAWS WITH SHEET METAL

EXTENSION WINGS - T²-30 ONLY

2. Insert a 3/8-24x1-1/4" hex head screw (not shown)

through a hole in the rear guide rail and table. Place a

3/8" flat washer, 3/8" lockwasher onto the screw. Thread

a 3/8-24 hex nut onto the screw. Repeat this process for

the remaining three holes in the rear guide rail and the

saw table.

3. Use a square (D) Fig. 8 to make sure the rear guide

rail is parallel with the table and tighten all hardware

securely that holds the rear guide rail to the table.

Fig. 7

Fig. 8

FENCE

1. Place the fence on the guide tube, lift up clamp (A)

Fig. 9, and place the fence over the rear guide rail and

gently push fence onto guide tube (B) Fig. 9. NOTE:

MAKE SURE THAT THE CLIP ON THE BACK OF THE

FENCE ENGAGES THE REAR GUIDE RAIL.

2. Push down on fence clamp (A) Fig. 10 to lock fence

in place.

Fig. 10

Fig. 9

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 36-729 User Manual Page 4