Delta Embedded DVR User Manual download pdf (Page 57)

In the main menu, from Setting to Detect, you can see motion detect interface. See X302H302H302HFigure 4-

19.There is three detection types: motion detection, video loss, camera masking.

4.5.2 Motion Detect

Detection menu is shown as below. See Figure 4-20

z Event type: from the dropdown list you can select motion detection type.

z Channel: select the channel to activate recording function once alarm occurred. Please make

sure you have set MD record in encode interface(Main Menu->Setting->Schedule) and

schedule record in manual record interface(Main Menu->Advanced->Manual Record)

z Latch: when motion detection complete, system auto delays detecting for a specified time.

The value ranges from 10-300(Unit: second)

z Region: Click select button, the interface is shown as in Figure 4-21. Here you can set

motion detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is

current cursor position. Grey zone is the motion detection zone. Black zone is the disarmed

zone. You can click Fn button to switch between the arm mode and disarm mode. In arm

mode, you can click the direction buttons to move the green rectangle to set the motion

detection zone. After you completed the setup, please click ENTER button to exit current

setup. Do remember click save button to save current setup. If you click ESC button to exit

the region setup interface system will not save your zone setup.

z Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.

z Show message: System can pop up a message to alarm you in the local host screen if you

enabled this function.

z Alarm upload: System can upload the alarm signal to the network (including alarm centre)

if you enabled current function.

z Send email: System can send out email to alert you when alarm occurs.

z PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to preset,

tour &pattern when there is an alarm. Click “select” button, you can see an interface is

shown as in

X305H305H305HFigure 4-22X.

z Period: Click set button, you can see an interface is shown as in Figure 4-23. Here you can

set for business day and non-business day. In Figure 4-23 click set button, you can see an

interface is shown as in Figure 4-24. Here you can set your own setup for business day and

non-business day.

z Anti-dither: Here you can set anti-dither time.

z Alarm output: when alarm occurred, system enables peripheral alarm devices.

z Tour: Here you can enable tour function when alarm occurs. System one-window tour.

Please go to chapter 5.3.9 Display for tour interval setup.

z Video matrix: Once you enable this function, the selected alarm channel will be displayed in

video output channel.

z Snapshot: You can enable this function to snapshoot image when alarm occurs.

z Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.

Please highlight icon

to select the corresponding function. After all the setups please click

save button, system goes back to the previous menu.

Note:

In motion detection mode, you can not use copy/paste to set channel setup since the video in

each channel may not be the same.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 161 162

Comments to this Manuals

No comments

Delta Embedded DVR User Manual Page 57

Comments to this Manuals

Related products and manuals for Digital Video Recorders (DVR) Delta Embedded DVR