Delta 50-762 Instruction Manual

INSTRUCTION MANUAL3 H.P. Dust Collector(Model 50-762 and 50-763)PART NO. A03571 - 06-15-05Copyright © 2005 Delta MachineryTo learn more about DELTA MA

10AFig. 8Fig. 9BFig. 10Fig. 10AABBABAATTACHING DUST COLLECTION BAGUSING CLOTH COVERED FLEXIBLE RING:1. Take cloth-covered bag retainer ring (A) Fig.

11ATTACHING ACCESSORY HOSE TO INTAKE PORTDISCONNECT MACHINE FROM POWERSOURCE BEFORE CONNECTING ORDISCONNECTING HOSE .Model 50-762/50-763 provides four

Fig. 14Fig. 15Fig. 16MODEL 50-763 SINGLEPHASE INSTALLATIONYour dust collector is supplied with a motor and amagnetic starter controller and must be pe

13FOR OPERATOR SAFETY, DO NOT OPERATE THE MACHINE WITH ANY DUST INTAKE HOLESUNCOVERED. THE ROTATING FAN LOCATED INSIDE THE BLOWER HOUSING IS ACCESSIBL

14MAINTENANCEPARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a

15NOTES

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

61. Motor and blower assembly2. Stand12Fig. 1CCARTON CONTENTS 34567893. Dust intake port4. Cloth-covered bag retainer ring (2)5. One micron upper filt

71011121415161718Fig. 1E1310. Caster (4)11. Intake cap and ring (4)12. Bracket for bag hanging rod (2)13. 5/16” (8mm) Large flat washer for bracket (2

8FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE I

9Fig. 5Fig. 4ABFig. 7CATTACHING DUST INTAKE PORTSPlace dust intake port (A) Fig. 7 over intake hole (B)opposite the motor. Align four holes (C) in the