Delta 50-850 Instruction Manual download pdf (Page 12)

12 - English

ASSEMBLING DUST INTAKE HOSES TO

BLOWER AND MOTOR ASSEMBLY

Keep dust caps installed at all times

over intake ports. Remove a dust cap only when a

flexible hose is attached to the intake port.

Always disconnect dust collector from

the power source before connecting or disconnecting

intake hose.

The dust collector is supplied with a 4" (101 mm) dia.

flexible dust intake hose.

1. To assemble the intake hose (A) Fig. 22, to the blower

assembly, pull the dust cap (B) from the dust intake

port (C) and slide the dust cap collar (D) farther onto

the dust intake port (C) as shown. IMPORTANT:

DO NOT REMOVE THE INTAKE CAP FROM THE

INTAKE PORT.

2. Place hose clamp (E) Fig. 22, on one end of flexible

hose (A) and assemble the hose to dust intake port

(C). Tighten hose clamp (E).

Fig. 22

For operator safety, do not operate the machine with any dust intake holes uncovered. The

rotating fan, located inside the blower housing, is accessible through the dust intake port and can be hazardous.

Always wear proper apparel. Do not wear jewelry. Keep your fingers and all foreign objects out of the dust intake

port. Follow the safety rules in this manual.

STARTING AND STOPPING THE DUST COLLECTOR

The "ON/OFF" switch is located on the side of the motor.

To turn the machine "ON", push the start button (A)

Fig. 23. To turn the machine "OFF", push stop button (B).

Make sure that the switch is in the

"OFF" position before plugging in the power cord.

In the event of a power failure, move the switch to

the "OFF" position. An accidental start-up can cause

injury.

LOCKING THE SWITCH IN THE "OFF"

POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the "OFF" position to prevent

unauthorized use, using a padlock (C) Fig. 24 with a

3/16" (4.8 mm) diameter shackle.

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 23

Fig. 24

Should you wish to operate your dust collector with a

second intake hose, contact

CUSTOMER CARE CENTER

at 1-800-223-7278

to purchase the hose and install as in

STEPS 1 and 2 above.

Whenever one of the dust intake ports is not in use,

always be sure the dust cap is properly installed in the

intake port for operator safety.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments

Delta 50-850 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Dust covers Delta 50-850