Delta AP400 Instruction Manual download pdf (Page 12)

Fig. 14

FILTER AND DUST COLLECTION

BAGS TO DRUM

1. Thread a 5/16-18 hex nut (A) Fig. 13, onto the end

of bag support rod (B). Thread rod into hole (E)

and tighten nut (A) against motor assembly to hold

support rod (B) upright. Height of support rod can

be adjusted after the filter bag is in place. The hook

in the support rod (B) should be positioned over the

drum. This can be accomplished by rotating the

support rod until the hook is positioned over the

drum (C) Fig. 13.

2. Hook the loop on the top of filter bag (F) Fig. 14,

onto the end of support rod (B).

3. Position open end of filter bag (F) Fig. 15, over the

lip of drum (G). NOTE: It may be necessary to adjust

the height of the drum support rod at this time. If

adjustment is necessary, loosen nut (A) Fig. 13, and

rotate support rod (B) as needed to obtain proper

rod height to support filter bag (F). Tighten nut (A) Fig.

13.

4. Place locking band (H) Fig. 15 around the filter bag

(F), through filter bag loops (L), and fasten filter bag

to drum by locking clamp (J) as shown in Fig. 15.

IMPORTANT: Make certain band (H) is positioned in

the channel of drum (G) before locking clamp (J).

5. Place the remaining locking band (H) Fig. 16, around

the dust collection bag (K) and collection bag loops

(M). Position open end of bag over the lip of drum

(G) and fasten with locking clamp (J). NOTE: Make

certain locking band (H) is positioned in the channel

of drum before locking clamp (J).

Fig. 13

Fig. 15

Fig. 16

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Delta AP400 Instruction Manual Page 12