Delta GR275 Instruction Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
ASSEMBLY TOOLS REQUIRED
Open end wrench (supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 30 minutes.
TOOL RESTS
1. Attach the left tool rest (A) Fig. 1 to the left tool rest arm (B) Fasten with one 5/16-18x3/4" knob (C) and 5/16" flat
washer (D). Loosely tighten for further adjustment. Attach the remaining tool rest.
2. Attach the left tool rest assembly (D) Fig. 2 to the inside of the left wheel guard (E) with two 5/16-18 x 1/2" screws (F)
and 5/16" flat washers (G).
3. Assemble and attach the right tool rest assembly to the inside of the right wheel guard.
4. Each tool rest assembly (D) Fig. 2 is adjustable. Each can be positioned slightly below the centerline of the wheel
and as close to the grinding wheel as possible, giving maximum support to the workpiece. Always maintain a
distance of 1/8" or less between the grinding wheel and the inside edge of the tool rest. As the wheels wear down,
adjust the tool rest accordingly. When the tool rest is positioned correctly, tighten the hardware (C) and (F).
Fig. 1
SPARK GUARDS
The spark guard (A) Fig. 3 is mounted to the side of each
wheel guard with a 1/4-20 x 1/4" hex head screw (B) and
1/4" (Larger OD) flat washer (C).
NOTE: Place the tab (D) Fig. 3 on the side of the spark
guard (A) in the slot (E) BEFORE attaching the spark
guard (A) to the grinder.
Adjust the spark guard (A) as close as possible to the
grinding wheel so that the sparks never strike your hands.
ASSEMBLY
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
Fig. 2
Fig. 3
A
C
B
D
D
G
C
F
E
A
C
B
D
E
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments