Delta 14-65l User Manual download pdf (Page 12)

12 - English

The column (A) Fig. 27 can be rotated 180 degrees for special cuts. To rotate the column, remove the four screws, two

of which are shown at (B), rotate the column (A) 180 degrees, and replace the four screws (B).

You must secure the base to a supporting surface.

ROTATING THE COLUMN 180 DEGREES

USING BITS WITH EXTRA LONG SHANKS

When using bits with extra long shanks, remove the extension (A) Fig. 28. Insert a screwdriver into the slot (B) Fig. 29 in

the end of the armature shaft on top of the motor. Use a chuck key to unscrew and remove the chuck (C) Fig. 28 and

extension (A). Remove the extension (A) from the chuck (C) and replace the chuck (C). You can also use the chisel

spacer. Place the chisel spacer (D) Fig. 30 on the chisel shank (F) and insert the chisel into the chisel holder. Tighten

the chisel holder securely.

Fig. 27

Fig. 28

Fig. 29 Fig. 30

MAINTENANCE

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp

cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the

outlet. Also, check for blown fuses or open circuit breakers in the line.

LUBRICATION & RUST PROTECTION

Apply household floor paste wax to the machine table, extension table or other work surface weekly. Or use a commercially

available protective product designed for this purpose. Follow the manufacturer’s instructions for use and safety.

To clean cast iron tables of rust, you will need the following materials: a sheet of medium Scotch-Brite™ Blending Hand

Pad, a can of WD-40

and a can of degreaser. Apply the WD-40 and polish the table surface with the Scotch-Brite pad.

Degrease the table, then apply the protective product as described above.

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the

DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Delta 14-65l User Manual Page 12