Delta 22-470 User Manual download pdf (Page 10)

Fig. 12

Fig. 11

Fig. 10

ELECTRICAL CONNECTIONS

The planer comes wired for 220 volt operation, but it can

be wired for 440 volts. Before connecting your machine

to an electrical power system, make certain the motor

rating agrees with the electrical system it is to be con-

nected to.

NOTE: All electrical connections should be done by a

qualified electrician and conform to the National Electric

Code and all local codes and ordinances.

NOTE: Power cord and plug are not shipped with the

planer. The standard machine is shipped wired for 220

volt operation. To wire the machine:

1. Loosen screw (A) Fig. 10, and remove cover (B) from

terminal box located at the rear of the machine.

Bring power line up through hole (C) Fig. 11, in the

terminal box. NOTE: Strain relief and power cord

clamp are not supplied with the machine. Remove

plastic shield (D) Fig. 11, from terminal strip (E).

2. Connect the three power lines to terminals (F), (G),

and (K) Fig. 12, and the green ground wire to termi-

nal (H). After applying power to the machine, jog the

power on and off to check if the machine is rotating

correctly. If the cutterhead is not rotating correctly,

interchange any two of the three power lines con-

nected to terminals (F), (G), and (K).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Delta 22-470 User Manual Page 10