Delta 22-470 User Manual download pdf (Page 14)

Fig. 24 Fig. 25

Fig. 23

CHECKING AND ADJUSTING TABLE

ROLLER HEIGHT

It is not possible to give exact dimensions on the prop-

er height setting of the table rollers because each type

of wood has different behavioral patterns. As a general

rule, when planing rough stock, the table rollers should

be set high (.003 to .005 ) above the table surface.

When planing finish stock, the table rollers should be

set low (.001 ) above or level with the table surface.

To check and adjust the height of the table rollers, pro-

ceed as follows:

Fig. 22

1. DISCONNECT THE MACHINE FROM

THE POWER SOURCE.

2. With the table rollers in the lowest position, lay a

straight edge (A) Fig. 22, across both table rollers (B)

on the left side of the table as shown.

3. With a feeler gage Fig. 23, measure the gap between

the table surface and the straight edge (A) near the

infeed roller (C).

4. If an adjustment to the infeed table roller is necessary,

loosen locknut (D) Fig. 24, which is located under the

table and below the infeed roller and rotate adjustment

nuts (E) as necessary to raise or lower the height of the

infeed roller. NOTE: It will be necessary to raise the

table to gain access to the adjustment nuts. Tighten

locknut (D) after adjustment is made.

5. Check and adjust the height of the infeed table roller

on the other side of the table in the same manner.

6. To check the height of the outfeed table roller, proceed

as follows: with a feeler gage (B) Fig. 25, measure the

gap between the table surface and the straight edge

(A) near the outfeed roller (F).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Delta 22-470 User Manual Page 14