Delta 22-470 User Manual download pdf (Page 21)

Fig. 48

Fig. 50

LEVELING THE TABLE

The table is set parallel to the cutterhead at the factory and

no further adjustment should be necessary. To check if the

table is level with the cutterhead, proceed as follows:

1. DISCONNECT THE MACHINE FROM

THE POWER SOURCE.

2. Check to see if the cutterhead knives are set correctly

as explained in section “CHECKING, ADJUSTING

AND REPLACING KNIVES.”

3. Then check to see if the table is set parallel to the cut-

terhead by placing gage block (A) Fig. 49, directly

under the cutterhead on the left hand side of the table

as shown. Raise the table until gage block (A) Fig. 49,

just touches the cutterhead.

4. Carefully move gage block (A) Fig.50, to the right hand

side of the table directly under the cutterhead. The dis-

tance from table to cutterhead should be identical.

Fig. 49

4. Place gage block (A) Fig. 47, under infeed roller (D).

The bottom of roller (D) should just touch gage block

(A).

5. If an adjustment is necessary, loosen locknut (E)

Fig. 48, and turn adjustment screw (F) until the

infeed roller just touches the top of gage block (A).

6. Repeat the adjustment on the opposite end of the

infeed roller in the same manner.

7. Tighten locknuts (E) Fig. 48, after adjustments are

completed.

Fig. 47

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Delta 22-470 User Manual Page 21