Delta 55531 Installation Guide download pdf (Page 2)

3. MOUNT GLIDE RAIL

A. Adhesive Bonded Mounting Procedure:

Clean Surface - If mounting tape only is used, the

wall surface must be thoroughly cleaned. To achieve

maximum adhesion, it is necessary that the surface be

free of any residue. If the wall surface is not absolutely

dry and clean, the self-adhesive backing will not stick

properly. To clean most surfaces, nail polish remover,

rubbing alcohol, or lighter ﬂuid can be used, (Be sure to

follow the precautions noted on the container.) A mild

abrasive cleaner should be used if silicone or wax has

been applied to the wall.

Mount Rail - Peel protective covering from tape, being

careful not to touch or otherwise contaminate the

adhesive Position rail and press ﬁrmly into place by

rubbing on the rail with the heel of your hand. NOTE:

For best results allow the adhesive to dry for a

minimum of 4 hours before using shower.

B. Screw Mounting Procedure:

Mark screw hole positions on the wall. Drill 1/4” holes as

near the center of the slotted holes as possible for the

screw anchors provided (use a carbide tipped drill for

ceramic tile or concrete).

Peel adhesive protective covering from Glide Rail and

install as in 3A above, being sure the slotted holes are

aligned with the screw anchors before pressing into

place. Install screws and tighten until the tape is slightly

compressed.

Replace chrome end caps by tapping on the caps lightly

with a hammer until they snap into place. Protect the

caps with a cloth or other soft substance while striking.

4. MOUNT HAND SHOWER

Mount the hand shower on glide rail and attach to water supply. Tighten hose

nuts sufﬁciently to slightly compress the urethane hose ends which act as

gasket seals.

www.deltafaucet.com

72633 Rev. B

1 2

No comments

Delta 55531 Installation Guide Page 2