Delta 37-360 Instruction Manual download pdf (Page 6)

3. Grounded, cord-connected machines intended for

use on a supply circuit having a nominal rating between

150 - 250 volts, inclusive:

If the machine is intended for use on a circuit that has an

outlet that looks like the one illustrated in Fig. C, the

machine will have a grounding plug that looks like the

plug illustrated in Fig. C. Make sure the machine is

connected to an outlet having the same configuration as

the plug. No adapter is available or should be used with

this machine. If the machine must be re-connected for

use on a different type of electric circuit, the re-

connection should be made by qualified service

personnel; and after re-connection, the machine should

comply with all local codes and ordinances.

4. Permanently connected machines:

If the machine is intended to be permanently connected,

the machine should be connected to a grounded metal

permanent wiring system, or to a system having an

equipment-grounding conductor.

Fig. C

GROUNDED OUTLET BOX

CURRENT

CARRYING

PRONGS

GROUNDING BLADE

IS LONGEST OF THE 3 BLADES

EXTENSION CORDS

Use proper extension cords. Make sure

your extension cord is in good condition and is a 3-wire

extension cord which has a 3-prong grounding type

plug and matching receptacle which will accept the

machine’s plug. When using an extension cord, be sure

to use one heavy enough to carry the current of the

machine. An undersized cord will cause a drop in line

voltage, resulting in loss of power and overheating. Fig.

D-1 shows the correct gauge to use depending on the

cord length. If in doubt, use the next heavier gauge. The

smaller the gauge number, the heavier the cord.

Fig. D-2

MINIMUM GAUGE EXTENSION CORD

RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES

Ampere Total Length Gauge of

Rating Volts of Cord in Feet Extension Cord

0-6 240

up to

50 18 AWG

0-6 240 50-100 16 AWG

0-6 240 100-200 16 AWG

0-6 240 200-300 14 AWG

6-10 240

up to

50 18 AWG

6-10 240 50-100 16 AWG

6-10 240 100-200 14 AWG

6-10 240 200-300 12 AWG

10-12 240

up to

50 16 AWG

10-12 240 50-100 16 AWG

10-12 240 100-200 14 AWG

10-12 240 200-300 12 AWG

12-16 240

up to

50 14 AWG

12-16 240 50-100 12 AWG

12-16 240

GREATER THAN 100 FEET NOT RECOMMENDED

FUNCTIONAL DESCRIPTION

Delta Model 37-360 and 37-361 (DJ-30) are 12" Precision Jointers with a cutting capacity of 12" (304mm) wide, 3/4"

deep (19mm max.) and 3/4" (19mm) rabbeting. Model 37-360 includes a three-phase 3 HP motor that is wired for 220V

(can be wired at 460V). Model 37-361 includes a single phase 3 HP motor wired for 230V. Both include a fence, three-

knife cutterhead, cutterhead guard, and push blocks.

FOREWORD

THREE PHASE OPERATION

Three phase jointers are not supplied with a power cord. They must be permanently connected to the building electrical

system and grounded according to the National Electrical Code. Since they must be permanently connected to the

building electrical system, extension cords cannot be used with three phase jointers.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Delta 37-360 Instruction Manual Page 6

Comments to this Manuals