Delta 37-360 Instruction Manual download pdf (Page 8)

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.

NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE

CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED

IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE

ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO

ILLUSTRATE TECHNIQUE ONLY.

REMOVING SHIPPING CRATE

1 - Dust Hood

2 - 8mm Hex wrench

3 - 12 and 14mm open end wrench

4 - 10 and 12mm open end wrench

5-5/8″ long Button Head

Screws (7)

6 - Push Blocks (2)

7 - 1-1/8″ long

Socket Head Screws (2)

8 - Flat Washers (2)

9 - Fence Assembly

10 - 4mm T-Handle wrench

(not shown)

11 - 3mm and 10mm Hex wrench

(not shown)

12 - 17mm and 19mm Open end

wrench (not shown)

Fig. 4

Your new 12″ Jointer is shipped complete in one wooden shipping crate. Remove the crate from around the machine

leaving the bottom of the machine fastened to the shipping skid at this time. Remove the fence assembly, dust hood

and all loose items from the shipping crate. Figure 4 illustrates all the loose items supplied with your machine.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Delta 37-360 Instruction Manual Page 8