Delta 40064 Installation Guide download pdf (Page 3)

P/N 27794 09/13

REQUIREMENTS FOR SUCCESSFUL INSTALLATION

CAUTION: DO NOT use drywall screws to secure anges to wall studs. Product damage will occur and will void the warranty.

◘ Read complete instructions before beginning installation.

◘ These instructions include suggestions for rough construction and plumbing installation that we believe to be reliable.

Local building codes vary and could supersede those suggestions. If you are not confident in your ability to perform

these tasks, contract out those tasks you need help with or use a professional installer.

◘ Confirm that your model will fit in intended location and plumbing fixtures are located where required before beginning

installation.

◘ Walls and sub-floor must be solid, plumb, and square.

◘ Use drop cloth to protect shower base from damage during installation.

◘ Do not install in areas where temperature may drop below 32ºF (0ºC).

◘ Allow product to reach room temperature for 30 minutes before installation.

◘ Two people recommended to install this product.

TOOLS AND MATERIALS REQUIRED

PencilSafety glasses

Drill

Drill bit

3/16" (5 mm)

Tape measure Drop clothShims

Adhesive

(2 tubes)

Sealant

(2 tubes)

1-1/4" screws

(zinc or stainless;

panhead or

roundhead)

2-1/2" construction

screws

Hole saw

(sized to

accommodate

plumbing fixtures)

Square Level

Utility knife

Caulk gun

Extension bit

holder

(recommended)

#2 Phillips bit

(for use with

extension bit

holder)

◘ 2” x 6" lumber for shower door/curtain rod reinforcement

◘ Lumber for bracing

◘ Rags or padding to protect product during bracing

TIP: You may want to install insulation.

1 2 3 4 5 6 7 8 ... 23 24

Comments to this Manuals

No comments

Delta 40064 Installation Guide Page 3

Comments to this Manuals