Delta 40064 Installation Guide download pdf (Page 5)

P/N 27794 09/13

WALL INSTALLATION

3. Verify Back Panel Fit

◘ Place drop cloth in shower base to protect surface while

installing shower walls.

◘ Position back panel, leaving an even gap on both sides of

back panel.

◘ Verify that back panel is straight and square.

4. Drill Holes in Back Panel Flange

◘ Drill 3/16" holes at all stud locations on top flange.

CAUTION: Drill 3/16" clearance holes into anges only.

Do not drill 3/16" holes directly into studs. Drill chuck can

damage panel. Use an extended bit holder to reduce risk of

drill chuck hitting panels.

1. Symbols and Description

APPLY ADHESIVE where indicated. Apply 1/4” to 3/8”

round bead.

APPLY SEALANT where indicated.

CAUTION: A situation which, if not avoided, could

result in property damage or other undesirable conditions.

Product damage will occur and will void the warranty.

IMPORTANT! Instructions which, if not followed, could

result in property damage. Product damage may occur

and will void the warranty.

2. Stud Placement

1-1/2"

(3,8 cm)

70-3/4"

(179,7cm)

IMPORTANT! Studs must be plumb and square to oor.

Inside corners must be square.

◘ Determine fixture locations for new plumbing installations

(See page 4, Roughing-In).

Install additional studs as shown for side panel support. Stud

length(2" x 6" lumber) must be 70-3/4" tall, located 1-1/2" from

the deck of the shower base and protruding in 2-1/8" from the

adjacent stud.

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Delta 40064 Installation Guide Page 5