Delta 34-814 Instruction Manual download pdf (Page 10)

1. The Magnetic Starter on/off switch (A) Fig. 9 comes

attached to a mounting bracket on the right side of

the machine. Remove it.

2. Insert a 5/16-18x1" flat head screw (D) with a 5/16"

flat washer (E) through the hole (G) in the front lip of

the extension table and through the switch bracket

(A). Use a 5/16-18 hex nut to loosely attach the

switch and switch bracket (A) Fig. 10 to the inside

front lip of extension table. with (F) through hole (G).

3. Attach the side of switch bracket (A) Fig. 11 to the

inside of the extension table using the 7/16-20x1-

1/4" screw (C) and 7/16" flat washer.

4. Tighten all hardware securely.

ATTACHING THE MAGNETIC STARTER ON/OFF SWITCH

Fig. 9

Fig. 10

Fig. 11

ATTACHING THE BLADE GUARD AND SPLITTER ASSEMBLY

DISCONNECT THE MACHINE FROM THE POWER SOURCE!

1. Remove the table insert Fig. 12. Raise the saw arbor by turning the height adjusting handle on the front of the saw

counter-clockwise as far as it will go. Then turn the angle-adjusting handle on the front of the saw clockwise as far

as it will go. Remove the saw blade from the machine by following the instructions in section “CHANGING THE SAW

BLADE”.

2. The inside splitter mounting bracket (A) Fig. 13 comes attached to the inside of the saw and was aligned with the

inside blade flange (B) at the factory.

Fig. 12

Fig. 13

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 10